Use the configuration wizard to initialize nodes in a cluster to the pre-determined
IP addresses.
Note
IP address configuration for
interfaces on the cluster must be set only once. If you change IP addresses after
initial deployment (for example, due to a cluster relocation), you must rebuild and
re-deploy the cluster, and re-install the application.
The following is example information that must be gathered during
the prerequisite stages for each node in the cluster, and for the ICC VRRP:
IP Address
A unique IP address for
each node. Example:192.227.109.81
Mask
Common Mask. Example:/26
(255.255.255.192)
Gateway
Common Gateway.
Example:192.227.109.65
VRRP Precedence
Common Router ID with a
unique precedence level for each node. Provide a unique precedence value
for each node.
